Rainy Days Ahead! Key Points for Loader Operation and Parking During the Rainy Season!

Consecutive days of rain pose numerous challenges for construction sites. As a primary piece of equipment, how should loaders be operated safely and parked properly in rainy weather? Keep these key points in mind!

Rainy Day Operation: Stability First, Vigilant Awareness

Always monitor road conditions during wet weather. Muddy surfaces are slippery—constantly observe surroundings. When pushing or shoveling materials, use low throttle and maintain steady operation. If the bucket struggles to engage, avoid sudden throttle increases that cause tire spin. Instead, try reversing to adjust position and load in stages.

Muddy ground may conceal sharp rocks. Prolonged tire slippage can cause cuts and accelerate wear. Install appropriate traction chains in advance, maintain proper tire pressure, and avoid sudden acceleration or braking while driving.

In narrow, deep water, or uneven terrain, have an excavator scout the route first, with the loader following for shoveling and transporting. Assign a dedicated spotter. If stuck, move at a steady, slow pace. Avoid emergency braking or raising the boom excessively, which can destabilize the center of gravity.

During rainy seasons, when using a loader as a tow vehicle, prioritize the loader's safety. Only by ensuring your own safety can you effectively assist others. Spread sand or gravel on muddy slopes for traction. Stay clear of dangerous areas like cliffs and ditches.

Rainy Season Storage: Rust and Moisture Prevention, Attention to Detail

Preferably store indoors to avoid damp environments. Keep working attachments dry. Periodically start the engine to charge the battery. Run the machine and drive it once a month to maintain battery charge. After extended storage, wipe dry the piston rods and replenish grease.

Chassis cleaning and inspection are critical. Clean the chassis promptly after operation, lubricate key components, check drain plug seals, and remove accumulated water to prevent rust.

Protect vital parts: Secure fuel tank and hydraulic tank caps, inspect air filters to prevent rain ingress. Apply moisture protection to engine oil ports, starter circuits, and generator connectors; cover with protective covers if necessary.

Finally, prioritize garage storage for loaders. Position the engine away from eaves to prevent direct rainwater exposure.

Emergency and Routine Maintenance

Immediately halt operations in excavation pits during rain. Secure electrical equipment against water ingress to prevent short circuits and electric shock hazards.

For mud-clogged buckets, use the limit block vibration function to unload material. Avoid violent impacts that could damage hydraulic cylinders or control cables.

Ensure comprehensive nighttime operation readiness: verify proper lighting and windshield wiper function, and remain vigilant against wind, collapse, and slippery surface hazards.

During rainy season construction, safety demands no compromise! Only through standardized operation and meticulous maintenance can we ensure swift loader performance and safeguard project progress.